NuTone QTNLEDA Guia de Instalação descarregar pdf (Página 4)

Page 4

MODEL QTNLEDA

SERVICE PARTS

99044705B

KEY NO. PART NO. DESCRIPTION

1 SQTHB1 HANGER BAR KIT

2 475 DUCT REDUCER 6” TO 4”

3 97018562 DUCT CONNECTOR - 6”

4 99111293 SPACER (2 REQ’D)

5 97016466 HOUSING

6 98010102 WIRING PLATE

7 99170245 SCREW, #8-18 X .375

8 97018552 WIRE PANEL/HARNESS ASSEMBLY

9 97018580 BLOWER ASSEMBLY

10 97018529 MOTOR PLATE & CONTROL ASSEMBLY

11 99420665 THUMBSCREW, #8-18 X .375

12 99260558 NUT (4 REQ’D)

13 99140199 GRILLE SPRING (2 REQ’D)

14 97018480 GRILLE ASSEMBLY

15 99271381 BULB, GU24, 18W FLUORESCENT (2 REQ’D)

16 99111530 RING

17 99111529 LENS

* 97018578 SERVICE ASSEMBLY, BLOWER

(INCLUDES KEY NOS. 9 THRU 12)

* Not shown assembled.

Order service parts by “Part No.” - not by “Key No.”

INSTALL GRILLE

5. Finish ceiling.

Install ceiling material. Cut out around housing.

7. Attach grille to

housing.

Squeeze grille springs

and insert them into

tabs on each side of

housing.

9. Remove light

lens.

Carefully insert a

small flat-blade

screwdriver between

grille and lens. Pry

lens out.

8. Push grille

against ceiling.

SERVICE NOTE To

remove Blower Assembly:

Unplug motor. Remove

thumbscrew (12) from

motor plate flange. Find

the single TAB on the

motor plate (located next

to the receptacle). Push

up near motor plate tab

while pushing out on side

of housing. Or insert a

straight-blade screwdriver

into slot in housing (next to

tab) and twist screwdriver.

Replacement parts can be

ordered on our website.

Please visit us at

www.nutone.com

WARRANTY

BROAN-NUTONE THREE YEAR LIMITED WARRANTY

Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of three years from the date of original purchase. THERE ARE NO OTHER

WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING.

This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan-NuTone), faulty installation

or installation contrary to recommended installation instructions.

The duration of an implied warranty is limited to the three-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR

INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the

above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number stated below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the

time of requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027 www.nutone.com 888-336-3948

10. Install light

bulbs.

Purchase (2) 18W

(max.), type GU24

fluorescent lamps with

M.O.L. (maximum

overall length) of 3.9”

(100mm) as illustrated

below.

Insert lamps and bulb

into their sockets.

Replace lens.

3.9" (100mm) M.O.L.

6. Plug in wiring.

Plug wiring into proper receptacles.

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

NuTone QTNLEDA Guia de Instalação Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com não NuTone QTNLEDA